SP Airtool stock a full range of valves.
Available in three sizes, 1/8", 1/4" and 1/2". Three versions,3/2, 5/2, 5/3 and four
different types of actuation - mechanical, manual, pneumatic and electric. Series 70 valves can be used
for a wide range of applications as they can be mounted in line, on the wall, or on the cylinder using
a special bracket or in series on a multiple or manifold base.
Available in size 1/8" only, versions 5/2 and 5/3 and with pneumatic and solenoid actuation. The
MACH 16 valves is a typical small size valve, only 16mm wide, with excellent performance, 750 NI/min flow
rate at 6 bar, P1 bar.
The valve can be used in line, on a panel, or on a base (multiple or manifold).
This MACH design is the result of the miniaturisation concept with the same durability, sturdiness and
reliability.
Multimach is not just a valve, it is an electro-pneumatic distribution 'island' - a single block ready for
connection to power and air delivery pipes and a multi-pin cable.
The flow micro-regulator regulates the speed of the piston rod in the pneumatic cylinders. The configuration
of micro-regulators type C (to mount on the cylinder inlet) and type V (to mount on the valve ports) gives full
flow during supply and regulated flow during exhaust.
With type B (bidirectional) both the supply and exhaust flow rates can be adjusted. The adjusting knobs on SP Air's
MFR's allows triple adjustment:manual operation on the milled section, screwdriver inserted in the relevant slot,
and using a hex spanner. The MRF ring can be orientated even when mounted.
LINE-MOUNTED FLOW MICRO REGULATOR WITH PUSH IN FITTING
Series RFL R
This LINE-MOUNTED flow micro-regulator with built in push-in fittings has the job to regulate the air supply
and thus the speed in pneumatic actuators.
Two versions are available:
-type U (unidirectional) regulates the flow only in one of the two directions of air flow.
Configurations:
Push-in fitting at the inlet and outlet
Push-in fitting at the inlet and threaded port at the outlet (cylinder)
Threaded port at the inlet and push-in fitting at the outlet (Valve)
-type B (bidirectional) regulates the flow only in both directions of air flow.
Configurations:
